Need help?Do you have a question about the Sun Oracle Sun Storage 2500-M2 Arrays and is the answer not in the manual?
General| Brand | Sun Oracle |
|---|---|
| Model | Sun Storage 2500-M2 Arrays |
| Category | Storage |
| Language | English |
Prerequisites and checks before starting the installation process.
Introduces the storage array family, controller trays, and expansion trays.
Lists required installation steps and references for detailed procedures.
Details components accessible from the front and rear of controller and expansion trays.
Describes disk drive capacity, mixing rules, and components.
Outlines the software used for managing the storage arrays.
Explains Customer Replaceable Units (CRUs) and the Service Advisor tool for support.
Guidelines for installing and configuring FC switches for the storage array.
Procedures for installing and configuring Host Bus Adapters (HBAs).
Cabinet requirements and checks before installing trays.
How to install adjustable support rails for mounting trays in a cabinet.
Detailed steps for securing support rails within the cabinet.
Procedures for physically installing controller and expansion trays into the cabinet.
Explains connecting multiple trays for expanded storage capacity.
Provides recommended cabling diagrams for connecting trays.
Details the process and cable requirements for connecting expansion trays.
How to set up management access via a separate Ethernet network.
Steps to connect Ethernet cables for out-of-band management.
How to use the data path for management traffic.
How to connect data hosts to the storage array.
Describes the different host ports on controller trays.
Details connecting host interface cables to the controller tray.
Decision points and prerequisites before powering on the array.
Procedures for connecting AC and DC power cables to the trays.
Step-by-step guide to powering on the storage array components.
Procedures for safely powering off the storage array.
Guidance on post-installation software setup and configuration.
Explains LED symbols and their general behavior.
Details the LEDs associated with disk drives.
Describes LEDs on the front and back of controller and expansion trays.
Defines sequence codes displayed on the controller tray's 7-segment display.
Explains the need for valid IP addresses for management connectivity.
Details methods for configuring IP addresses on controller modules.
Describes methods for assigning static IP addresses to controller Ethernet ports.
Steps for configuring IP addresses via the serial port interface.
Requirements for configuring a DHCP server, including MAC addresses.
Example procedure for setting up a DHCP server on Solaris.
Guide to setting up DHCP on a Windows 2000 Advanced Server.
To Next Page