Sunbeam 32610003 - Dry Ironing; Steam Ironing; Spray Mist; Shot of Steam

-6- -7-
DRY IRONING
1. Insert the plug in the electrical wall socket.
2. Make sure that the Steam Select Switch is in the closed position .
3. After the Indicator Light goes off, you may start to iron.
STEAM IRONING
Steam ironing is only possible at high temperatures (silk, wool, cotton, linen),
as indicated on the Temperature Control Dial
(figure 3).
1. Be sure that there is enough water in the
Reservoir.
2. Set the iron in an upright position.
3. Plug the steam Iron into the wall electrical
outlet.
4. Turn the Temperature Control Dial to
the desired position within the range of
temperatures included in the steam area
of the dial.
5. Wait until the Indicator Light has turned off
after lighting up.
6. Set the Steam Select Switch to the desired steam level position. You are
now ready to start steam ironing. The steam will be released evenly through
vents located in the soleplate for easier ironing.
SPRAY MIST
The Spray Mist feature is a powerful water spray mist that dampens the fabric
to help remove wrinkles from heavy fabrics and to set creases.
1. Press the Spray Mist button firmly to start the spray.
(gure 3)
SHOT OF STEAM
®
The Shot of Steam
®
feature provides an extra burst of steam for deep
penetration of stubborn wrinkles. The Shot of Steam
®
feature can be
used with dry or steam ironing provided it has at least a ¼ tank of water
and the Temperature Control Dial is set within the steam band.
1. Allow the iron to heat for approximately two minutes.
2. Press the Shot of Steam
®
Button several times to prime the pump.
3. Press the Shot of Steam
®
Button another three to four times in order
to clean the unit.
4. The Shot of Steam
®
feature is now ready for use. The Shot of
Steam
®
feature can be used continuously with just a short pause
between shots. The Shot of Steam
®
feature is most effective with the
Iron held in a horizontal position on the fabric being ironed.
5. If the Water Reservoir runs dry, unplug the Iron and refill with water.
The Iron may be filled with water while it is hot. Note: It may be
necessary to re-prime the pump before using the Shot of Steam
®
feature again.
VERTICAL SHOT OF STEAM
®
The vertical Shot of Steam
®
feature allows your iron to function as a garment steamer.
Tip: When using the vertical Shot of Steam
®
on clothing, hang the clothing
on clothes hanger for best results. Hanging curtains and drapes may also be
steamed.
HOW TO USE VERTICAL STEAM
1. Allow iron to warm up.
2. Hold the iron in a vertical position, with the iron close to but not
touching the fabric you want to steam.
3. With your other hand, pull the fabric tight.
4. Press the Shot of Steam
®
button in approximately 3-second intervals
as you move the iron across the wrinkled area.