EasyManua.ls Logo

Sunbeam Brita WF6000 - Care and Cleaning; General Cleaning Procedures; Emptying the Internal Tank; Help Line

Sunbeam Brita WF6000
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
HeadingCare and Cleaning
Help Line
If you have any additional questions about using the Water Filter & Chiller, please call the
Sunbeam help line in Australia on 1300 881 861. In New Zealand, please call 0800 786 232.
For BRITA
®
filter cartridge and Memo enquiries, contact BRITA
®
Customer Care.
In Australia please call 1300 557 762. In New Zealand, please call 0800 427 482.
Do not use harsh detergents or abrasive
cleaners.
Do not place any part of this appliance in a
dishwasher.
Wipe the base with a clean cloth or paper
towel.
Wash the filtering tank in warm, soapy water
using a mild detergent.
Wipe the inside of the filtered water tank
with a damp cloth which has been soaked
in water.
Do not immerse the base in water or any
other liquid.
If the unit is to be moved or stored for a
prolonged period of time without being
used, we recommend that you drain the
internal tank of any water. Flush the unit as
described before using again.
Emptying the internal tank
Switch off the appliance and unplug from
the mains.
Remove the lid and the filtering thank and
any water in the filtered water tank.
Turn the appliance upside down to reveal a
drain plug located in the centre of the base.
Using a $2 coin or a suitable screw driver,
turn the plug anti clockwise until it is fully
loosened. Please note that it cannot be
completely removed.
Drain the tank.
Insert the plug after draining and using
a $2 coin or suitable screwdriver, turn it
clockwise until it stops.
Do not over tighten as this may damage
the plug.
10

Related product manuals