Sunbeam EM0450 - Adjusting Burrs for Wear

9
Care and Cleaning (continued)
9.Replacethetopburrbackintoposition
inthegrindadjustmentcollar.Ensurethe
markeronthetopburrisalignedwiththe
markerinsidethegrindadjustmentcollar
andpushfirmlyintoplace.
Turnclockwisetothedesiredgrindsetting.
Adjusting the burrs for wear
Theconicalburrsaremadeoftool
hardenedsteelforextralonglife.However
afterprolongedusetheburrswillrequire
adjustmenttocompensateforwear.Asignof
thisiswhenthegrindsarenotasfineasthey
usedtobe,checkbyrubbingsomeofthe
grindsbetweentwofingersorforespressothe
extractionwillalsoshowsignsthatthegrind
needsadjusting.
Replacing the burrs
Toinquireabouthavingtheburrsreplaced
contacttheSunbeamConsumerHotlineon
Australia
1300881861
New Zealand
0800786232