5
Before Using Your High Performance Blender
CAUTION: Never put the jug or any other
parts in a microwave. Never store foods or
drinks in the jug.
Tamper
• The tamper allows you to accelerate
the process of very thick and/or frozen
mixtures that cannot be processed in a
regular blender. If food is not circulating the
machine may be overloaded or may have a
trapped air bubble. Using the tamper helps
to maintain circulation by preventing air
pockets from forming. While the machine is
running, remove the filler cap and through
the hole in the lid insert the tamper and use
it to press ingredients into the blades as you
make frozen ice creams, nut butters, etc.
• The container should not be more than
2/3 full when the tamper is used during
blending.
• Do not use tamper for more than 20
consecutive seconds (to avoid stressing
the motor).
• You may need to move the tamper not
only up and down, but also side to side.
Interlock
• The unit is supplied with an interlock
on the base. This will prevent the motor
or the control panel from starting if the
blender jug is not properly placed on the
base. If the jug is removed from the base
during operation the unit will stop.
• To restart the blender turn the speed dial
to OFF, place the jug on the blender base
and select the preferred speed to begin
again. The motor will not restart unless
the unit is turned OFF first.
If the Unit Stops Working:
• Fuse/Overload Protection – The motor
is designed to protect itself from
overheating. When necessary, the motor
will turn itself off.
1.
Turn control knob to “Off” and unplug
from the electrical outlet
2.
Remove jug from base and free blade of
any obstructions
3.
Press external resettable fuse button on
the bottom of the base
4. Wait 30-45 minutes for the unit to cool.
• If the warning light flashes and the motor
will not run with the jug in place, the
unit has not cooled sufficiently. Turn the
control knob to OFF and wait another
10-20 minutes before trying again.
To Next Page
Loading...
