Using your MashMaster
It is recommended to wash the wand of your
MashMaster in warm soapy water with a soft
cloth. Rinse and dry thoroughly.
The top section of the mashing wand
that includes the gearbox, should not be
immersed in water and should be cleaned
with a soft damp cloth.
Important: Before using your MashMaster
remove any packaging material and
promotional labels or tags.
Important: Ensure that the MashMaster is
unplugged from the power outlet before
assembling or removing attachments.
1. Insert the motor housing into the wand and
twist the wand in a clockwise position until
you hear a click. See Figure 1. The gear
box is attached between the motor housing
and the mashing wand.
2. Plug the power cord into a 230-240 volt
power outlet and turn the power on.
3. Lower the stick mixer into food and
select from speed 1 through to 9 (on
StickMaster
®
Platinum model) and depress
the power button (
) or setting ( )
at the top of the motor housing.
Note: All stick mixers are designed to
operate only when the power buttons remain
depressed.
4. To stop the stick mixer, take your finger off
the power or turbo speed button.
5. To detach the wand, twist the shaft in
an anti clockwise position until the wand
unscrews from the motor housing.
See Figure 2.
4
Figure 2
Figure 1
To Next Page