Suncast BMS8125 - Site Preparation and Foundation Construction; Foundation Options and Site Prep

11
Site Preparation and Platform Construction
Materials NOT supplied with Shed Kit
Note: Site preparation is required for this shed. Placing the shed on one of the constructed foundations detailed below
is required. Without a constructed foundation, settling will probably occur, causing distortion and damage to the shed.
Suncast is not responsible for replacing parts damaged or property lost due to incorrect assembly. Warranty r
equires foundation.
Note: Complete the site preparation and foundation construction before unpacking parts and beginning assembly. For
tips on site preparation, go to www.suncast.com, consult retailer, or local code.
To prepare your shed site, follow the steps below:
1) Consult your local authorities for building codes and covenants before beginning foundation or erecting shed.
2) Before any digging, check with local utilities to determine location of buried cables, pipes, etc.
3) Decide which type of foundation you want:
- Concrete slab, 4" thick
- Wood platform
Use exterior grade wood. The wood platform should be set on pier blocks or footing. Consult your local retailer for
help to determine the best anchoring method for your particular installation. The provided plans are sized for the
minimum number of cuts to lumber and plywood.
4) Prepare the building site:
- The ground should slope away from the foundation area to provide drainage.
- The foundation surface must be at and level.
- A vapor barrier should be provided to prevent excessive condensation in the shed.
- Follow local building codes for a proper vapor barrier.
5) Anchoring the shed to the foundation:
- Consult your local retailer for help to determine the best anchoring method for your particular installation.
- To secure the shed to a concrete slab, use masonry fasteners available at your local hardware retailer.
- To secure the shed to a wood platform, use 1/4" x 3" long lag screws with washers.
Anchoring oor panel to concrete slab
• Secure shed to concrete slab using masonry
fasteners.
• Dimensions allow for shed to t within the nearest
1" on each side.
Anchoring oor panel to wood platform
• Secure shed to wood platform using 1/4" x 3" lag
screws.
OR