Need help?Do you have a question about the Sundown Audio SCY-2000D and is the answer not in the manual?
General| Signal to Noise Ratio | > 90 dB |
|---|---|
| THD | < 0.1% |
| Input Sensitivity | 6V - 0.2V |
| Low Pass Filter | 35 Hz - 250 Hz |
| Subsonic Filter | 10 Hz - 50 Hz |
| Phase Shift | 0 - 180 degrees |
| Efficiency | > 85% |
| Damping Factor | > 200 |
| RMS Power at 1 Ohm | 2000W |
| RMS Power at 2 Ohms | 1200W |
| Peak Power | 4000 Watts |
| Frequency Response | 10Hz - 350Hz |
| Bass Boost | 0 - 12 dB |
| RMS Power at 4 Ohms | 700W x 1 @ 14.4V |
Details on Class-D linkable design, MOS-FET power supply, 1 Ohm stability, filters, bass boost, phase shift, protection, and remote control.
Key performance specifications including rated power output, frequency response, input sensitivity, and fuse ratings.
Highlights features of full range digital and class A/B amps, including multi-channel design and stable loads.
Details on crossover multipliers, protection circuits, and wired remote control functionality.
Guide for connecting the positive battery wire, including fusing requirements.
Instructions for establishing a secure chassis ground connection for the amplifier.
Details on connecting the remote turn-on wire from the source unit or ignition.
Diagram showing RCA connections for input, output, and remote control on monoblock amps.
Wiring diagrams for 1-ohm and 2-ohm speaker loads to monoblock amplifiers.
Instructions for setting master and slave units and transferring signals via RCA.
Details on minimum impedance (2 ohms) and potential damage for strapped/linked amplifiers.
How to connect subwoofer voice coils to master and slave amplifiers correctly.
Illustrates RCA connections for full range 2-channel amplifiers, including remote control.
Wiring for connecting speakers in 2-channel mode to the SAX-175.2 amplifier.
Wiring for connecting speakers in 3-channel mode to the SAX-175.2 amplifier.
Diagrams for RCA connections on SAX-100.4 and SAX-150.4 4-channel amplifiers.
Wiring diagram for connecting speakers in 3-channel mode on 4-channel amps.
Wiring diagram for connecting speakers in 4-channel mode on 4-channel amps.
Wiring diagram for connecting speakers in 5-channel mode on 4-channel amps.
Steps to check fuses, voltage, input signal, and speaker connections.
Diagnosing issues like speaker shorts, input voltage, and impedance load.
Checks for ground connections, amplifier controls, speaker wiring, and input signal.
To Next Page
