How to troubleshoot a SunHome Plumbing Product chiller that won’t turn on?
If your SunHome Plumbing Product chiller doesn’t work, and the controller doesn't light up with no sound from the fan or compressor, check the power supply including wiring and fuses.
Why is my SunHome Plumbing Product chiller running but not cooling properly?
If your SunHome Plumbing Product chiller works but provides insufficient cooling and displays the temperature without error codes, consider the following: * Install a larger model or use an extra chiller cover for the pool. * Check the electrical wiring of the fan and replace the condenser or fan motor if needed. * Check the electrical wiring of the compressor and replace the condenser or compressor if necessary. * Ensure sufficient air circulation. * Set the correct temperature. * Have the by-pass readjusted by the installer. * Have the chiller checked by a refrigeration technician.
What to do if my SunHome Plumbing Product chiller won't stop running?
If your SunHome Plumbing Product chiller doesn’t stop running and the controller displays the temperature without any error codes, inspect the parameters and adjust or correct them if necessary, ensuring these settings are just above the chiller’s capacity. Also, check the pressure switch’s operation by turning off the unit’s filter pump and restarting it; if the chiller doesn't react, the pressure switch may need adjustment or replacement.
How do I resolve outlet water over-cool protection in my SunHome Plumbing Product?
If the outlet water of your SunHome Plumbing Product is experiencing over-cool protection, unblock any jams, increase the water flow volume, or repair/replace the water pump.
How do I fix a high-pressure switch failure in my SunHome Plumbing Product?
To address a high-pressure switch failure in your SunHome Plumbing Product, try reconnecting the switch. If that doesn't work, replace the switch.
What to do if the inlet water temperature sensor fails in my SunHome Plumbing Product?
If the inlet water temperature sensor fails on your SunHome Plumbing Product, try reconnecting the sensor. If the issue persists, replace the sensor.
How do I troubleshoot an ambient temperature sensor failure in my SunHome Plumbing Product?
If the ambient temperature sensor fails on your SunHome Plumbing Product, try reconnecting the sensor. If that doesn't solve the problem, replace the sensor.
Critical safety advice for operating the electrical appliance and potential risks involved.
General| Brand | SunHome |
|---|---|
| Model | Cold Plunge Pro |
| Category | Plumbing Product |
| Language | English |
To Next Page