sunjoe SJPPH48 - Flame Characteristics and Tips; Interpreting Flame Characteristics; Operational Tips and Safety; Extinguishing the Heater

9
iii. Repeat step 4.
7. After the burner is lit, adjust the temperature by rotating
the lighting knob. Turn the lighting knob counterclockwise
to "HIGH" position (pointing to the big red dot). If you want
a lower temperature, turn the control knob clockwise to
the "LOW" position (pointing to the small red dot) (Fig. 14).
mWARNING! FOR YOUR SAFETY
If at any time you are unable to light burner and smell gas, wait
at least 5 minutes to allow gas to dissipate before attempting
to light the gas appliance again.
Flame Characteristic
The ame can be checked through the emitter screen during
operation. The normal ame should be mostly blue with yellow
tip. Abnormal ame characteristics include:
• The ame extends beyond the emitter screen.
• Black spots can be seen accumulating on the emitter
screen or the reector assembly.
If any of the above situations appears, turn o the heater
immediately and contact the Snow Joe
®
+ Sun Joe
®
customer
service department at 1-866-SNOWJOE (1-866-766-9563).
The heater should not be used again before it's serviced or
repaired.
Operation Tips
mWARNING! When use the heater for the rst
time, avoid inhaling fumes emitted from the heater. The fumes
contain smoke and odor from the burning of oils used in
manufacturing. The fumes will dissipate after approximately 30
minutes. The heater should NOT produce thick black smoke.
mWARNING! Do not touch or move the heater for
at least 45 minutes after use. Allow the heater to cool down
completely.
mCAUTION! Items above, beside or under this
heater while in use will be subject to radiant heat and could be
seriously damaged.
mWARNING! This heater must be placed on level,
rm ground.
mWARNING! Never operate in an explosive
atmosphere. Keep away from areas where gasoline or other
ammable liquids or vapors are stored or used.
• This heater is designed for the heating of outdoor patios,
decks, spas, pools and open work areas. Always make
sure that adequate fresh air ventilation is provided. Follow
the spacing tolerances shown in the following gure at all
times (Fig 16).
• When initially turned on, it's normal for the heater to
produce some noise. If this happens, turn the lighting
knob to the LOW position (pointing to the small red dot).
Wait for a while and then adjust the knob to the desired
temperature.
• When the heater is on, the emitter screen will become
bright red due to the intense heat. The blue ame can be
seen through the emitter screen.
• If the ame appears to be mostly yellow or there's heavy
black smoke produced by the heater, there may be an
obstruction of airow. If this happens, turn o the heater
and contact the Snow Joe
®
+ Sun Joe
®
customer service
department at 1-866-SNOWJOE (1-866-766-9563).
• If the ame appears to be very small, this may be caused
by the insucient pressure. Change or rell the propane
cylinder.
• If the heater extinguished accidentally, rotate the lighting
knob to the OFF position (pointing to the black dot), wait
for 5 minutes and follow the instruction in Lighting the
Heater section from step 2 to relight the heater.
NOTE: Always wait for 5 minutes before relighting.
Extinguishing
1. Push in and turn the lighting knob counterclockwise to
OFF position (pointing to the black dot) (Fig. 14).
2. Close the propane cylinder valve when appliance is not
in use. Disconnect and remove the cylinder if the heater
needs to be transported or stored.
Fig. 15
Emitter
screen
Ignition
hole
91 cm
61 cm
61 cm
Fig. 16