12
Troubleshooting
m
WARNING! Always unplug the power cord before performing any adjustments, maintenance or repairs to your
electric wet/dry vacuum.
Device does not start Mains voltage is not present Check power supply – cord, breakers, fuses.
If damage is found, contact a qualied
electrician to repair
Switch on the equipment
Contact Snow Joe
®
customer service at
1-866-SNOWJOE (1-866-766-9563) to repair
Attach or replace the nylon mesh lter
Check the unit for blockage. Clean or
replace the nylon mesh lter.
The equipment is not switched ON
The collection tank is full
Defective appliance cord or ON/OFF switch
Defective motor
The nylon mesh lter is missing or damaged
There is a blockage in the nozzle, hose, or air inlet.
The nylon mesh lter is clogged by ne dust
Dust comes out from
motor cover
Problem Possible Cause Possible Solution
Empty the collection tank
To Next Page
Loading...
