Sunlighten mPulse cONQUER Assembly Instructions

STEP 6
After all four U-clips are inserted
in the corners, the next step will be
to place the roof on top. The roof will
also reinforce the walls in position along
with the clips.
NOTE: The roof may require some slight
manipulation to fall into place on top of
the wall panels.
STEP 7
5
Lights, Blaupunkt/
Sound Therapy Receiver
D15
D16
E8
D17
After the roof is placed, remove the dust covers.
There should be the connections to the lights and
speakers at the top front. Connect those so you
can turn on the lights and listen to sound.
• Connect 3-pin rectangular plug (D15 – two red,
one white) into E5.
• Connect E5 to SP-Amp.
• Connect D17 RCA plugs (one red and one white)
to left side of SP-Amp.
• Leave D16 cable 4-pin, white rectangular
connector and second D15 3-pin rectangular
connector unplugged unless you purchased the
Sound Therapy Kit.
• If Sound Therapy was purchased, plug D15 and
D16 into E8.
• Plug E8 into SS-Amp.
E5
E
5
5
sunlighten.com/gb-en
4

Sunlighten mPulse cONQUER Specifications

General

Brand	Sunlighten
Model	mPulse cONQUER
Category	Plumbing Product
Language	English