K
STEP 8
The dust cover should be replaced to protect
the lights and speakers from dust and other
floating residue. As mentioned in STEP 5, there
are four connections to be made in each bottom
section of the walls. If you have not yet done so,
consult with the diagram at the bottom of this page.
After all four floor connections have been made,
replace the floor covers as mentioned in STEP 2,
then please install the bench . Make sure the
heater frames are not mounted, otherwise they
will prevent the bench from resting on the
supports.
Now, place the heater frames in their respective
locations. NOTE: Look at the back of the heater
frames for the “This Side Up” sticker for proper
orientation.
Left Wall Heaters
Back Wall Heaters
Right Wall Heaters
Front Wall Heaters,
Lights, Blaupunkt/
Sound Therapy
Receiver, Control
Panel
K
sunlighten.com/gb-en
6
To Next Page
Loading...
Need help?
General
