Cabin Cleaning and Maintenance | Page 3
General Maintenance
• Use dry cloth to dust the exterior.
• Unplug the unit twice a year for at least 15 minutes.
• Drape towels over the bench to decrease sweat
accumulation.
• Do not cover more than 40% of the oor grate.
• Keep unit unplugged if unattended for long periods
of time (e.g., vacation).
• (mPulse specic) - Use can of spray air, similar to what
you would use on your computer, to clear out dust/
debris from the heat syncs on the power box twice a
year. (Heat syncs are the spike-looking objects on the
back side of the power box, which is found directly
under the bench beneath wooden covers)
Outdoor Units
• You must have a Sunlighten Sauna Cover installed per
the instructions, in order to place your unit outside; to
keep your warranty intact.
• Twice a year in mild, dry weather, remove the cover
to inspect for tears/holes/worn spots in the fabric and
plastic liner. If you nd tears/holes/worn spots, you will
need to replace your Sunlighten Sauna Cover.
• One to two times a year, make sure wires have not
been damaged by rodents or pests.*
• mPulse power box found directly under the bench
has a lot of wiring. There is also connection point
on the oor directly under the Android Control
Panel.
• Signature has a single stretch of wiring
immediately to the right of the oor grate. You will
have to slide a board out to get to the wiring.
*There is no oor heater for an Amplify - all of the
wiring is up within the roof panel and walls.
heat syncs
mPulse power box with
heat syncs
Signature wiring
To Next Page
Loading...
Need help?
General
