© 2021 Sunman (Zhenjiang) Co., Ltd. All rights reserved. Specifications included in this manual are subject to change without notice.
www.sunman-energy.com
version 2021A page 5 / 29
Handling safety
• Do not lift eArc by grasping eArc’ junction box or electrical leads.
• Do not stand, step or walk on any side of eArc.
• Do not drop eArc or allow objects to fall on eArc.
• Do not place any heavy objects on eArc.
• Be cautious when placing eArc down onto a surface, particularly when placing it in a corner.
• Inappropriate transport and installation may damage eArc panel and void the warranty.
• Do not attempt to disassemble eArc, and do not remove any attached nameplates or components from
eArc.
• Do not apply paint or adhesive to eArc’ top surface.
• To avoid damage to the front cover and backsheet: do not scratch, dent or hit the front cover and
backsheet.
• Do not drill holes in the ribs. This may compromise the frame strength, cause corrosion of the ribs and
void the warranty.
• Do not scratch the anodized coating of the ribs (except for grounding connection). It may cause
corrosion of the ribs or compromise the ribs strength.
• A panel with broken front plate or torn back sheet cannot be repaired and must not be used since
contact with any panel surface or the ribs can cause an electric shock.
• Work only under dry conditions, and use only dry tools. Do not handle panels under wet conditions
unless wearing appropriate protective equipment.
• When storing uninstalled panels outdoors for any period of time, always cover the panels and ensure
that the front cover faces down “on a soft flat surface” to prevent water from collecting inside the panel
and causing damage to exposed connectors.
To Next Page
Loading...
