Lifting Components
Squeegee Components
Number
Description Quantit
1
y
1
Lifting Rod
2
Washer
2
3
Pin
2
4
Eccentric Bushing
2
5
Washer
2
6
Screw
2
7
Nut
2
8
Pedal Cover
1
9
Pedal
1
10
Spring Pin
1
11
Bolt
2
12
Pin
1
13
Washer
1
14
Cotter Pin
1
15
Rod
1
16
Nut
2
17
Pin
1
Warning: do this operation when you wear gloves to
avoid direct touch on the dangerous liquids.
Replacement of the Squeegee Rubber Strips
When the rear wheel of the squeegee is worn, it will not dry the floor well. If such situation emerges, you can remove the
squeegee and replace it. If you want to replace the squeegee, please follow these steps:
➢ loosen the screw（6） and turn off the water suction motor.
Warning: Do this operation when you wear gloves
to avoid direct touch on the dangerous liquids.
Warning: disconnect the power source and pull out
the key when repairing it.
➢ The height of squeegee shall be adjusted by
the rubber situation (see ”adjusting the height
of squeegee support parts”).
➢ Select butterfly screws in the horizontal
position.
➢ Dismantle the rear rubber（5）to make
replacement.
➢ Make sure the main power switch is in the “0”position. Warning:
disconnect the power source and pull the key out when the
machine is in maintenance.
➢ Remove the rubber fastener and link the nuts. （6,7）
➢ Select the butterfly nut in the horizontal position.
➢ Take down the rubber and replace it.
➢ Dismantle the rubber (4) and replace it with a new one.
To Next Page
Loading...
