VACUUM TUBE / SOLID STATE HYBRID
DESIGN EMPLOYS THE BEST OF BOTH
TECHNOLOGIES
CONSTRUCTED IN AN ALL STEEL
CHASSIS FOR ENDURING RELIABILITY
1200 WATTS OF POWER @ <.2% T.H.D.
TWO CHANNELS WITH CLEAN AND
DISTORTED MODES
FOOTSWITCH JACK FOR REMOTE ON-
OFF SWITCHING OF THE GRAPHIC
EQUALIZER, COMPRESSOR AND
CHANNEL SELECTION
EFFECTS LOOP FOR SIGNAL
PROCESSING DEVICES
SPLIT BAND COMPRESSOR
REMOVABLE RACK MOUNT EARS
Congratulations on your purchase of a sunn
®
1200s
Bass Amplifier. Built with care and special attention to
detail, your new sunn 1200s Bass Amplifier offers
much more than meets the eye. Each 1200s bass
amplifier is crafted from the finest components
available and assembled at the Sunn amplifier
factory in Corona, California, USA.
sunn
®
1200s Bass Amplifiers include among their
many features: 1200 Watts of power (2Ω load); active
compression circuitry and a 10-band graphic
equalizer and high and low frequency controls for full-
bodied tonal shaping. The two channels are voiced
for both clean and distorted outputs offering the
versatility of differing playing styles. The footswitch
circuitry allows for remote selection of the front panel
graphic equalizer, compressor and the channel
selection. Moreover, the rear panel features an effects
loop for the addition of external signal processing
devices or outboard gear, a tuner out jack for
accessing your tuner and both XLR and 1/4 inch line
out jacks and a pass through jack for routing your
bass signal to another amplifier or mixing console.
In order to thoroughly understand the operation,
features and functions of your new sunn
®
1200s
Bass Amplifier, please read and refer as needed to
this operation manual. By doing so, your amplifier is
sure to provide you with years of trouble-free music
making and maximum playing enjoyment.
Take the time to get to know each other... Tune-up,
Plug-in and ... Play On!
WARNING:
-TO PREVENT DAMAGE, FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN
OR MOISTURE.
-NO USER SERVICEABLE PARTS INSIDE,
REFER SERVICING TO QUALIFIED PERSONNEL
ONLY.
-ALLOW AT LEAST 3 INCHES (7.6 CM) IN THE
FRONT AND REAR OF THE UNIT FOR PROPER
VENTILATION. DO NOT BLOCK VENTS.
-THIS UNIT MUST BE EARTH GROUNDED.
SUNN 1200s BASS AMPLIFIER
3
To Next Page
Loading...
