To Next PageTo Next PageWhy Sunny Health & Fitness SF-T7610 won't start?
Your Sunny Health & Fitness Treadmill may not be starting because it is not plugged into the outlet. In this case, plug the cord into the outlet. Another reason could be that the safety key is not inserted. Make sure to insert the safety key.
General| Brand | Sunny Health & Fitness |
|---|---|
| Model | SF-T7610 |
| Category | Treadmill |
| Language | English |
Always unplug the treadmill from the electrical outlet immediately after use and before cleaning.
Never leave the treadmill unattended when plugged in. Unplug when not in use or before changing parts.
Use extreme caution when stepping onto or off the moving belt to avoid injury.
Consult your physician before starting any exercise program and be aware of your body's signals.
Use the equipment on a solid, flat level surface with adequate clearance around it.
Ensure all nuts and bolts are tight. Check for damage and unusual noises.
Hold handrails when starting, then step onto the belt once it's moving. Change settings while holding handrails.
The safety key stops the treadmill in an emergency. Machine functions only when the key is inserted.
Use light finger pressure on console controls to avoid damage. Supervise children when present.
Unpack contents, place Main Frame (A03) on a leveled surface for assembly.
Attach Base Support Tubes (A02) to Base Frame (A01) using bolts and nuts.
Pull the Locking Pin (C25), lower Main Frame (A03) to the floor carefully.
Connect Handrail Brackets (A05) to Handrail Connecting Bracket (A04) by turning clockwise.
Insert Lock Knob (B09) and turn clockwise to secure the Base Frame (A01) to the Main Frame (A03).
Turn the Console Display (B) to a right angle. Assembly is now complete.
Keep the unit clean by dusting. Clean both sides of the running belt to prevent dust accumulation.
Adjust belt tension for optimal performance. The belt should be pulled out 50-75mm.
Raise one side of the Running Belt (C13), apply lubricant to the Running Board (D12), and wipe evenly.
Loosen Lock Knob (B09) counterclockwise, pull it out, and fold up the Main Frame (A03).
Ensure the product is plugged into a properly installed and grounded outlet with the correct configuration.
Never use GFCI outlets or generators. Keep the treadmill away from moisture and rain.
SPEED, TIME, DISTANCE, and CALORIES displays show workout progress. Understand each display's function.
START button begins workout, STOP pauses/ends. MODE selects programs. SPEED +/- adjusts speed.
Treadmill beeps and shows 'OIL' icon every 188 miles. Refer to Page 11 for lubrication.
Remove Safety Key (C32) to stop. Treadmill enters Power Saving Mode after 10 minutes of inactivity.
Use the power switch to turn the treadmill ON or OFF. Flick the switch to the correct symbol.
Troubleshoot common problems like 'Treadmill will not start' or 'Running speed inaccurate' with suggested actions.
Address motor abnormalities or control board errors by checking connections, voltage, or replacing parts.
