7
EXERCISE COMPUTER
KEY FUNCTIONS:
MODE: Press the red button to select a function.
(Time, Count, Total Count, Calorie and Scan)
OPERATION PROCEDURES:
1. AUTO ON/OFF:
If the steps of the machine are put into motion, or the mode button is pressed, the
computer will activate and will remain active while in use. If there's no signal for
approximately 4 minutes, the computer will automatically turn off.
2. RESET:
The computer can be reset by pressing and holding the red MODE button for three
seconds. Removing the batteries will also reset the computer and return all function
settings back to zero (except Total Count).
3. MODE:
To select the LOCK MODE setting press the red MODE button when the pointer is on
the function you wish to select and begins to blink. Once locked, only the selected
function will be displayed.
4. FUNCTIONS:
TIME: Counts the total time of an exercise from start to finish.
CALORIES: Counts the amount of total calories burned during an exercise from start to
finish.
COUNT: Automatically accumulates the count of steps made during exercise.
TOTAL COUNT: Automatically accumulates the count of steps made during all exercise
sessions, previous and current.
SCAN: Press the red MODE button until the arrow points to SCAN. Once on SCAN, the
arrow will continue to flash indicating that SCAN mode is active. SCAN will
automatically scan through each function in sequence.
CHANGING THE BATTERY:
NOTE:
1. If there is an improper display on the monitor, please replace the battery to improve
results.
2. This meter uses (2) two AA batteries.
To Previous Page
Loading...
