Installation & Operation Manual for the 5
Active Vibration Cancellation (AVC) System
Install the Accelerometer
Attach the AVC accelerometer (figure 4) (Sunpower part number 300AD-99678-108-015) to the end plate of the
CryoTel cryocooler with the provided #5-40 bolt into the end plate of the cryocooler (figure 5). If the cryocooler
is an older model not equipped with a #5-40 threaded hole, then use a small amount of super glue to attach the
accelerometer onto the end plate in the location shown in figure 5.
Figure 4. AVC Accelerometer Cable
Figure 5. AVC Accelerometer Installed with a Screw onto a Cryocooler
To Next Page
Loading...