Need help?Do you have a question about the SunPower CryoTel Series and is the answer not in the manual?
General| Brand | SunPower |
|---|---|
| Model | CryoTel Series |
| Category | Accessories |
| Language | English |
Crucial safety guidelines and operational prohibitions to prevent damage and ensure correct usage.
Instructions for safely removing the cryocooler from its packaging and initial handling.
Details on how to physically attach and integrate the cryocooler into a system using mounting holes.
Guidance on connecting heat loads to the cold tip, including force and torque limits.
Importance of vacuum at the cold end for optimal performance and methods to achieve it.
Information about electrical feedthroughs, their handling, and connection of the power cable.
How to mount and connect a temperature sensor for proper cooling control and feedback.
Details on using the water jacket for heat rejection, including installation and water flow requirements.
Guidelines for using copper fins with a fan for heat rejection, including airflow recommendations.
Considerations for using other solid conduction methods for heat rejection and consulting Sunpower.
Steps to prepare the cryocooler and system before initiating operation, including vacuum setup.
Procedures for connecting power, verifying polarity, and starting the cryocooler for operation.
Instructions for safely shutting down the cryocooler and allowing it to warm up.
Details of RS-232 communication parameters like baud rate, data bits, and stop bits.
Pin numbering and function for I/O and RS-232 connections on the controller unit.
Explains fundamental terminal emulator commands for controlling the cryocooler's basic functions.
Commands for setting control mode (PID), saving settings, and managing user-defined power output.
Commands to display and set the soft stop mode for controlled shutdown of the cryocooler.
Commands to check soft stop status and set user-defined maximum and minimum power limits for the cryocooler.
Commands to display power readings and configure thermostat functionality for cryocooler shutdown.
Commands for thermostat status, and adjusting proportional (KP) and integral (KI) constants for temperature control.
Commands to set temperature band, user password, and lock/unlock controller parameters.
Commands to display controller parameters, serial number, error codes, and reset to factory defaults.
To Next Page