SunPower Maxeon - Page 16

MAXEON SOLAR TECHNOLOGIES, LTD.
537620 Rev.I
©2024 Maxeon Solar Technologies, Ltd. All rights reserved. Specifications included in this document are subject to change without notice. 15
2 Test loads are for informaon purposes only, design loads should be considered for the project design.
3 Design Load considers 1.5 Factor of Safety, Test load = Design load x 1.5. Product Warranty covers only design
load values. The design loads listed in this table supersede all other loads that may be defined by other
pares, unless there is a formal authorizaon by Maxeon.
GEN 4.4 FRAME PROFILE
A - Ground Holes (4X Ø 4.2mm)
B - Mounng Holes (4X 9mm (W) x 14mm (L), R4.5mm)
SunPower Performance 7 AC Residenal Solar Panel
(SPR-P7-XXX-BLK-E10-AC)
SIDE FRAME PROFILE
END FRAME PROFILE
1 In the cases where hybrid mounng is necessary (combinaon of long and short side mounng), the lowest
design load values should be considered as allowable design load.
4 Boom flange mounng
30 mm
32 mm
Measurement Tolerances are +/-3mm for the Length and Width of the module.
5 Range indicates posioning of the clamp and not the rails
Mounng
Configuraon
Descripon
Mounng Configuraon Diagram
Front View
Back View
Mounng Zone
Locaons
(distance from corner
in mm)
50 - 270
Long Side Mounng,
Rails Perpedincular
to Mounng
Frame
Long Side Mounng,
Rails Parallel to
Mounng Frame
Short Side Mounng,
Rails Parallel to
Mounng Frame
(End Mount)
445 - 680
+3600/-2400
+3000/-2400
+2700/-2400
+3000/-2400
+2400/-1600
+2000/-1600
+1800/-1600
+2000/-1600
TOP CLAMPS
Short Side Mounng,
Point Supported
(End Mount)
270 - 445
+3600/-2400
+2400/-1600
Long Side Mounng,
Point Supported
0 - 100 +2400/-1700
+1600/-1133
Test L oad

Downward/Upward
(Pa)
Design Load
Downward/Upward
(Pa)

445 - 680
270 - 445
50 - 270
+3000/-2400
+2000/-1600
0 - 323
+3000/-1700
+2000/-1133

223 - 323
+2700/-1700
+1800/-1133

100 - 323
+1200/-1200
+800/-800

290 - 445
445 - 680
+5400/-2400
+4000/-2400
+3600/-1600
+3000/-1600
Short Side Mounng,
Rails Perpendicular
to Mounng Frame
(End Mount)









6 Slight bending may occur due to weight of the module.
30 mm
32 mm
MICROINVERTER
EXCLUSION ZONES
1134 mm
1790 mm
0
A
0
323
1100 mm
445
270
0
0
50
680
B
323
445
270
50
680
68.8 mm
280 mm
457 mm
457 mm