www.sunred.nl
SAFETY
CAUTION: Before fitting or removing the appliance, ensure that the heater's power line supplying the
heater is disconnected. Check that the power line is connected to a 30mA differential circuit breaker.
- This appliance is designed for use in gardens
- When it is switch on, an electrical heating appliance reaches very high temperature to cause burns.
Make sure that all other users are aware of the risks.
- If you have any doubts concerning installation possibilities for this heater, please consult a
qualified electrician.
- Children may not always be aware of the danger 'involved in using electrical appliances. Never
allow this appliance to be used without supervision.
- The appliance must be positioned so that the plug is accessible.
- If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or
similar qualified person in order to avoid a hazard
- The heater must not be located below a socket outlet
- Do not use this heater with a programmer, timer or any other device that switches the heater on
automatically, since a fire risk exists if the heater is covered or positioned incorrectly.
- Do not place the appliance close to curtains and other combustible materials.
HOW TO ASSEMBLE
- Before installing your appliance, you must disconnect the electrical supply at the circuit breaker.
- Use the four screws to fix the bracket of the heater on the wall on a right position and then fix the
heater on the bracket.
OPERATION
The appliance is switched on by means of the pull switch. The slight vibration noticeable when the
appliance is switched on will stop after a few seconds.
OUTPUT
Model: PHP-2000D
-Position 0: Stop
-Position 1: 650W (normal power)
-Position 2: 1300W (intermediate power)
-Position 3: 2000W (full power)
MAINTENANCE
Your appliance does not require any particular maintenance. However, in
the event of a malfunction, please consult an approved service center.
To Next Page
Loading...
