To Next PageTo Next PageWhat to do if LCD window shows an E4 error message on Sunrise Tradex Fellini 13-04553?
If your Sunrise Tradex Air Conditioner displays an E4 error, it means the water tank is full. You should drain and empty the water tank.
Why is air cooling not efficient in my Sunrise Tradex Air Conditioner?
Inefficient air cooling in your Sunrise Tradex Air Conditioner can stem from several causes: the room's humidity might be too low (below 30%), frost could be present on the evaporator, the air filter might be dirty, the temperature setting could be inadequate, there might be a heat source in the room, or the hot air exhaust hose might not be correctly installed. Here are some things you can do: * Increase the humidity level in the room. * Wait for the unit to complete its defrosting cycle if frost is present. * Clean or replace the air filter. * Increase the temperature setting and fan speed. * Remove or shield any heat sources in the room. * Verify the hot air exhaust hose is properly installed and insulated.
What to do if LCD window shows an E1 error message on Sunrise Tradex Fellini 13-04553 Air Conditioner?
If your Sunrise Tradex Air Conditioner's LCD window displays an E1 error message, it indicates an unstable power supply affecting the unit's operation. Turn off the air conditioner and wait for 10 minutes before turning it back on. If the E1 error persists, contact SUNRISE TRADEX Service.
General| Brand | Sunrise Tradex |
|---|---|
| Model | Fellini 13-04553 |
| Category | Air Conditioner |
| Language | English |
