6. Pull the starter grip again until the engine starts as normal.
7. When the engine is running and idling, the throttle lever on handle is as below picture.
First press the lock off lever and then switch the throttle lever on, the machine will be
working.
8. Adjusting line length when working: This machine is fitted with a
“Tap & Go”head.To
release more line, tap the cutting line head against the round with engine at top speed: the
line will be released automatically and the knife cut off the excess length.
9. If meet any problem occurs, press the engine switch, the machine will stop running.
If need stop cutting head working, release the throttle lever.
15
To Next Page