SUNWIND El-dorado Plus - Installation Process

32
The toilet is connected to an electric socket; this
MUST be a grounded outlet, with a minimum of
a 10A slow fuse box. In the event of any other
appliances on the same circuit, this should be at
least 16A. Alternavely, consult your electrician
about installing a separate circuit for the toilet.
Avoid any use of extension cords, power strips,
or mul-outlet adapters.
Should the oor be slippery so that the toilet
may slide during visits, it should be secured
to the oor. Remember to ensure that there
are no heang cables underneath the brackets
where you are securing the toilet. Brackets and
screws are enclosed in the box for the toilet.
Unplug the toilet from the electric socket when it
is not being used for an extended period of me.
The toilet is now ready for use. Connect the
toilet to the electric outlet and ensure that
the on/o switch is in the “ON” posion.
The toilet’s combuson should be tested
prior to the rst visit. To test the toilet, press
the combuson buon located at the top of the
toilet. Compleng one combuson takes about
75 minutes, aer which the toilet is ready for
normal use.
Fixing
brackets for
the oor.
Installaon
English