15
other side to Mist exit on the machine body. Total steps finished.
Installation the Water Tank
3) Open the door and take out the water tank by vertically upper
direction.
4) Let the water up-side-down, loosen out the water inlet, Put
water inside till full Then fasten the water inlet cap. Purified
water is better requested.
5) Converse the water tank to check if the cap fasten well, then
put the water tank onto the humidifier’s base flatly and close
the door.
Operation
Make sure this unit is connected to 220-240V~ voltage.
On the condition of connection power supply, power indicator
light on, fan is under standby mode. Both electric buttons and
remote controller can be operated. (Put two batteries in the
remote controller before using)
“On/Speed/Off” : This button’s sequence is : Low--Medium—Hig—
Off--Low again by press one more time.
“Wind Mode” : Choose mode of wind,such as Normal Nature
Sleep…Cyclic selection.
1) Normal wind: Unit will work at Low-Medium-High speed.
To Next Page
Loading...