SUNWIND RMF013 - Troubleshooting; Common Issues

18
Problems Reasons Handing ways
1.The fan
doesn’t work
when plug
in.
4. Motor failed to
action
5. Power is too
low
6. Rotation shaft
shut down
7. PCB shut
down
8. Weak welding
in capacity
5. Turn on the high speed
mode
6. Adjust the power to rated
power
7. Slightly knock the motor
cover or send to maintain.
8. Send to maintain(change
the same model PCB)
9. Check the welding or
change same model
capacity.
2.Obvious
shaking
1.Rear guard is loose
2.Blade fastening
screw is loose
3.Blade is not stable
or damaged
4.Blade is not
balance
1.Fasten the rear guard
2.Fasten the blade screw
3.Change the blade
4.Turn the blade 180°then
assemble
3.Atomizer
operates
well but no
mist outlet
1. Alkaline solution in
water tank
2.Water tank is
damaged and the
water leakage full
filled the flume
1.Repeat cleaning the tank
and atomizer
2.Pour out the water in flume
and change a new water tank
4.Atomizer
failed to
operate
1.The floater is not
floating up
1. Float up the floater by hand.
5.Indicator
light on but
no wind ,no
mist
1. Plug is not inserted
well
2.Power switch is not
turn on
1. Insert plug well
2.Turn on the power switch
6.Indicator
light on,
wind comes
out but no
mist
1. There lack of
water in the water
tank.
2. Mist function is not
selected.
3.Float cover is not
pressed well
1.Fill with water in water tank
2. Select the mist function
3.Press float cover well
7.The mist is
smelly
1.New product—the
smell will gone after
a period using
1.Open the water tank for 12
hours in the cool place
2. Change the water always.