Super Boost Ultra WiFi Pro Super Booster User Manual

WIFI BOOSTER MANUAL
LED Explanation
Power LED NO: The device is power on.
OFF: The Device is not receiving electrical power.
WLAN LED: Wireless signal
WPS LED: Flashing - WPS connection is established or WPS signal
LAN LED: ON: The LAN port is connect
OFF: The LAN port is disconnected
Flashing: Transferring data to/from a network device
Button Explanation
WPS Button: If your host router supports WPS function, you can press the WPS button and then press the
WPS button of the Wi-Fi Repeater to establish a secure connection between the host router and the WIFI
Repeater.
Reset Button: This button is used to restore The Repeater's factory default settings With the Repeater
powered on. Use a pin to press and hold the Reset button for about 8 seconds.
LAN Port: One 10/100 Mbps RJ45 Ethernet port is used to connect an Ethernet-enabled device to a Wi-Fi
network, such as Internet TV, DVR, Gaming console and so on Please note that this port cannot be
connected to a router.
QUICK INSTALLATION
1- POWER ON
Plug in next to your router; wait until the WLAN LED is blinking.
2-Connect
For window users

Super Boost Ultra WiFi Pro Super Booster Specifications

General

Brand	Super Boost
Model	Ultra WiFi Pro Super Booster
Category	Repeater
Language	English

Summary

Device Indicators and Controls

LED Status Explanations

Details the meaning of Power, WLAN, WPS, and LAN LEDs for device status.

Physical Interface Functions

Explains the usage of WPS button, Reset button, and the LAN port.

Quick Installation

Power On Procedure

Steps to power on the device and observe initial LED status.

Initial Connection Setup

Instructions for initial connection for specific user types.

Connecting to the Repeater

Wireless Connection Setup

Instructions to connect your computer to the Repeater's Wi-Fi network.

Wired Connection Setup

Instructions to connect your computer to the Repeater via an Ethernet cable.

Configuring Repeater Mode

Accessing Configuration Interface

Steps to launch a web browser and log in to the repeater's settings.

Setup Wizard and Options

Overview of the configuration interface and available setup options.

Finalizing Repeater Setup

Network Selection and Key Entry

Select host network and enter security key for extended network.

Applying Settings and Reboot

Apply changes and wait for the repeater to restart for settings to take effect.

Using Repeater as Network Adapter

Wireless Adapter Functionality

Connect Ethernet-enabled devices to your wireless network via the repeater.

Ethernet Device Connectivity

Connect Ethernet-only devices to the repeater using an Ethernet cable.