Removing the chuck jaw inserts
1. Remove the hex socket set screws with the
appropriate hexagonal key.
2. Remove the springs and spring retainers.
3. Install the hex socket set screws.
Screw in the hex socket screws until you can turn
Lubricate the bearings for the hollow spindle through
the two grease nipples in the head stock.
Check that all chuck mounting screws are tightened.
Clean and lightly oil the reamer cone and shaft.
1. Clean the die head and dies.
2. Check dies for any broken teeth or pipe scrap
This machine is produced with great precision;
therefore, should the machine fail to operate normally,
do not repair it by yourself, but call us for repairs.
If parts are required or if you have any questions,
please contact us, at your earliest convenience.
To Next Page
Loading...