21
22
Place F16, F1R and F1L combinations on
the working table.
Try to fit the F1R onto the F16
combination. Make sure the angle
between two combinations is 90 degree.
Place some heavy thing on the F1R and
use instant glue to secure the F1R on the
F16 combination.
Try to fit the F1L onto the F16. Make sure
the angle between two combinations is
90 degree.
Place some heavy thing on the F1L and
use instant glue to secure the F1L on the
F16 combination.
Top view of the front fuselage.
Place the F10, F11, F12, F13, F14, F19
and F28 on the working table as the
picture shown.
Try to fit the F10, F11, F12, F13 and F14
into the fuselage. Check if planking can fit
into the right side of fuselage.
Make sure all the planking can fit into the
left side of fuselage. Use rubber band to
the hold the fuselage and use clip to
secure the tail in place for temporary.
Make sure the front and rear part is
aligned and straight.
Use instant glue to secure the contacting
places.
Make sure the alignment of both side
boards on the tail.
Rear view of the tail fuselage; make sure
it is bilateral symmetry.
To Next Page
Loading...
