57
Place the machine gun decal, 4mm plastic
tube, balsa barrel, and F40 butt on the
working table.
Insert the plastic tube into the barrel. Use
instant glue to secure the barrel onto the
F40. Place a straight rule on top of it;
make sure the top of the machine gun is
straight. Drop some instant glue to secure
the plastic tube into the barrel.
Apply the decorative sticker on the front of
the barrel. Use scissors to remove the
excess sticker.
Apply the decorative sticker on both sides
of butt.
Apply the black sicker around the butt.
Color the parts w/o decal on the machine
guns into black.
58
Apply the decorative sticker on the barrel.
Place the machine guns inside the slots on
the canopy and use 2.0x6mm tapping
screw to secure them in place.
The top view of the machine guns on the
canopy.
Place the pilot inside the pilot seat. Use
2.6x8mm tapping screws and 3x10mm
washers to secure the pilot in place. Don't
screw too tight for avoiding thread
damage.
Completion of the canopy.
When install the canopy into fuselage;
make sure its front can be fitted into the
latch on the fuselage; press the canopy
into its location, the locking spring will get
stuck and won't lose off easily. Move the
locking spring backward can remove the
canopy for changing battery very easy.
To Next Page
Loading...
