EasyManua.ls Logo

Supera SSUD18-1 - Maintenance

Supera SSUD18-1
15 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INSTRUCTION
MANUAL
©SUPERA
V.1.0 | October 2014
4. Wait for watering after closing the door
a. Automatically fill up the water to the tank
b. After finished filling up the watering, turn water lamp, detergent feeding
and detergent lamp off, then turn stand by lamp on
5. Wash
a. Put the dishes into the rack
b. Put the rack into the machine
c. The door actuation system will close the door automatically
6. Rinse the dishes and rinse aid feeding
a. After finishing the wash cycle, automatically operate as programmed
7. Finish
a. Buzz for the finish and finish & standby lamp on
MAINTENANCE
Tips for Washing
Scrap the dishes to remove large particles of food and debris (prewash)
Arrange the dishes in the rack. Don’t stack dishes one on top of another as
water must have free access to all sides of every dish
After filling a rack, open the door, slide rack into the dishwasher and close the
door
Tip for Cleaning Dishwasher
1. Period for cleaning
a. The machine must be thoroughly cleaned at the end of each working
shift
b. Never use steel wool to clean the dishwasher
2. Clean
a. Push off the power button
b. Drain wash water by taking out the drain pipe and strainer
c. Clean off the strainer
d. Cleanse and flush inside of the dishwasher and remove a remaining soil
with soft cloth or brush
e. Replace all removed parts and leave the machine door open for drying