Superaxe WS300 - SPECIFICATIONS; AUSSIE CHOPPER; SUPERAXE

Page 14
13. TROUBLE SHOOTING
PROBLEM
SYMPTOM
REMEDY
ENGINE
Engine won’t start
Engine won’t run properly
or stalls easily in normal
operation
Switch off
Low oil/petrol
Flooded
Choke off
Choke on
Dirty air cleaner
Dirty fuel/spark plug
Relief valve setting too high
Turn on
Check
Dry out
Switch on
Switch off
Clean
Clean/replace
Consult manufacturer
Consult you engine dealer if further diagnosis, service or repair is required
HYDRAULICS
Engine runs but axe won’t
move
Hydraulic oil low
Sus. Pump/drive condition
Broken valve lever
Control lever/s damaged
Ram damaged
Top up oil
Test/repair/replace
Replace
Repair
Repair
Lack of splitting
power / speed
Low oil
Suspect pump
Valve not fully opened by
hand control
Relief valve set too low
Engine performance suspect
Ram seals worn
Machine operating on a
steep angle
Top up oil
Test/repair/replace
Repair hand control
Adjust
Service/repair engine
Replace
Operate on level ground
Oil leaking from filler
breather
Oil tank over full
Machine operating on a
steep angle
Drain some oil
Operate on level ground
For more detailed information or spare parts, contact the manufacturers