EasyManua.ls Logo

Superformance Mk III - Individual Specifications

Superformance Mk III
21 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page xv
LIST OF FIGURES
[Figure 1 - Superformance Mk III] ...........................................................1
[Figure 2 – Superformance Mk III Chassis, Front View] .........................5
[Figure 3 – Superformance Mk III Chassis, Rear View] ..........................5
[Figure 4 – Typical 4, 5, and 6-speed Shift Patterns]................................9
[Figure 5 – Superformance Chassis Number].........................................19
[Figure 6 – Hood Latches] ......................................................................36
[Figure 7 – Trunk Handle] ......................................................................37
[Figure 8 – Gas Cap]...............................................................................38
[Figure 9 – Door Latch] ..........................................................................39
[Figure 10 – Caution. Hot Exhaust Below Door Sill].............................40
[Figure 11 – Raise Hook]........................................................................41
[Figure 12 – Insert Eye] ..........................................................................41
[Figure 13 - Latch] ..................................................................................41
[Figure 14 – Five Point Harness] ............................................................42
[Figure 15 – Tonneau Cover]..................................................................43
[Figure 16 – Tonneau Cover, Driver’s Side Open].................................43
[Figure 17 – Folded and Ready To Stow Behind Seats].........................44
[Figure 18 – Tonneau Cover, Both Sides Open].....................................44
[Figure 19 – Install Top Bows]...............................................................47
[Figure 20 – Slip Pins in Rails into Slot in Windscreen Frame].............47
[Figure 21 – Catch on Windscreen Post] ................................................48
[Figure 22 – Clip Dot Fasteners around the Cockpit].............................48
[Figure 23 – Spread Top Bows]..............................................................49
[Figure 24 – Fold Window Over Top] ....................................................50
[Figure 25 – Fold Sides Over].................................................................50
[Figure 26 – Fold Front Section Over window]......................................51
[Figure 27 – Fold in Half].......................................................................51
[Figure 28 – Install Bows] ......................................................................52
[Figure 29 – Locate Pin] .........................................................................53
[Figure 30 – Lock Over Center Clip]......................................................53
[Figure 31 – Connect Tenax Fastener]....................................................54
[Figure 32 – Connect Dot Fasteners] ......................................................55
[Figure 33 – Tension the Top] ................................................................55
[Figure 34 – Secure Bows with Velcro]..................................................56
[Figure 35 – Roll Seal]............................................................................56
[Figure 36 – Lay Out Soft Top] ..............................................................58
[Figure 37 – First Fold]...........................................................................59
[Figure 38 – Second Fold] ......................................................................60