12
WIND CIRCULATION (MODE)
• With the “MODE button“, you may select from two modes of wind speed, namely “NORMAL“ and
“RHY“ (see diagram).
CLEANING AND MAINTENANCE
Caution:
Before cleaning, always unplug the device from the mains.
• The device, power cord and plug must not be soaked in water or other liquids during cleaning.
Clean these parts using a dry cloth.
• When very dirty, the outside of the device can be wiped off carefully with a damp cloth and
subsequently carefully dried. Be careful when doing so that no moisture gets inside the device.
• Do not use any harsh cleaning agent, wire brushes, abrasives or other hard objects to clean which
could scratch the surfaces.
• Clean the device regularly.
• Never use solvents, petrol or oil-based cleaners, since these could damage the housing.
• Check the visible screw attachments on the device regularly, to ensure it continues to operate
properly.
To Next Page
Loading...
