Superior SSDVT-4035CNM - User Manual

RETAIN THESE INSTRUCTIONS
FOR FUTURE REFERENCE
OTL Report No. 116-F-29-5
INSTALLATION
INSTRUCTIONS
Millivolt Models Electronic Models
MODELS
P/N 700,029M REV. E 11/2006
DIRECT VENT GAS FIREPLACE HEATERS
DIRECT VENT
SSDV-35/40 SERIES
SSDVT-3530CNM
SSDVR-3530CNM
SSDVT-4035CNM
SSDVR-4035CNM
SSDVT-3530CNE
SSDVR-3530CNE
SSDVT-4035CNE
SSDVR-4035CNE
A French manual is available upon request. Order P/N 700,029CF
Ce manuel d’installation est disponible en francais, simplement en
faire la demande. Numéro de la pièce 700,029CF.
This appliance may be installed in an aftermarket
permanently located, manufactured home (USA
only) or mobile home, where not prohibited by
local codes. This appliance is only for use with
the type of gas indicated on the rating plate. This
appliance is not convertible for use with other
gases, unless a certifi ed kit is used.
In the Commonwealth of Massachusetts:
• Installation must be performed by a licensed plumber or
gas fi tter;
• See Table of Contents for location of additional Com-
monwealth of Massachusetts requirements.
FOR YOUR SAFETY: Do not store or use gasoline
or other fl ammables or liquids in the vicinity of
this or any other appliance.
FOR YOUR SAFETY: What to do if you smell gas:
• DO NOT light any appliance.
• DO NOT touch any electrical switches.
• Do not use any phone in your building.
• Immediately call your gas supplier from a
neighbor’s phone. Follow your gas suppliers
instructions.
• If your gas supplier cannot be reached, call
the fi re department.
Installation and service must be performed by
a qualifi ed installer, service agency or the gas
supplier.
WARNING: IF THE INFORMATION IN THIS MANUAL
IS NOT FOLLOWED EXACTLY, A FIRE OR EXPLO-
SION MAY RESULT CAUSING PROPERTY DAMAGE,
PERSONAL INJURY OR LOSS OF LIFE.
POUR VOTRE SÉCURITÉ: Ne pas entreposer ni
utiliser d'essence ni d'autre vapeurs ou liquides
infl ammables dans le voisinage de cet appareil ou
de tout autre appareil.
POUR VOTRE SÉCURITÉ: Que faire si vous sentez
une odeur de gaz:
• Ne pas tenter d'allumer d'appareil.
• Ne touchez à aucun interrupteur. Ne pas vous
servir des téléphones se trouvant dans le bati-
ment où vous vous trouvez.
• Evacuez la piéce, le bâtiment ou la zone.
• Appelez immédiatement votre fournisseur de
gaz depuis un voisin. Suivez les instructions du
fournisseur.
• Si vous ne pouvez rejoindre le fournisseur de
gaz, appelez le service dos incendies.
L'installation et service doit être exécuté par un
qualifi é installeur, agence de service ou le fournis-
seur de gaz.
AVERTISSEMENT: ASSUREZ-VOUS DE BIEN
SUIVRE LES INSTRUCTIONS DONNÉ DANS CETTE
NOTICE POUR RÉDUIRE AU MINIMUM LE RISQUE
D'INCENDIE OU POUR ÉVITER TOUT DOMMAGE
MATÉRIEL, TOUTE BLESSURE OU LA MORT.

Summary

INSTALLATION INSTRUCTIONS

Direct Vent SSDV-35;40 Series

Identifies the specific direct vent gas fireplace models.

Models

GENERAL INFORMATION

Manufactured Home Requirements

Safety & Warning Information

Provides critical safety and warning information for safe operation and installation.

MASSACHUSETTS REQUIREMENTS

Carbon Monoxide Detectors

Details requirements for installing carbon monoxide detectors.

Manufacturer Requirements

SAFETY AND WARNINGS

General Safety Warnings

Covers critical warnings about fire, explosion, property damage, and personal injury.

High Surface Temperature Warning

Gas Leak and Carbon Monoxide Poisoning

Warns about gas leaks and carbon monoxide poisoning symptoms and actions.

VENT TERMINATION CLEARANCES

Vertical Vent Clearances

Horizontal Vent Clearances

HORIZONTAL VENT CLEARANCES

Minimum Clearances

DETAILED INSTALLATION STEPS

Step 1: Framing

Guides the user through constructing the appliance framing and securing it.

Step 2: Routing Gas Line

Explains how to route the gas supply line to the appliance location.

FIREPLACE SPECIFICATIONS

Vertical Venting Through Ceiling

FIREPLACE FRAMING SPECIFICATIONS

Proper Gas Line Sizing

Guides on properly sizing and routing the gas supply line according to codes.

INSTALL THE VENT SYSTEM

Vent Restrictor Installation

VERTICAL VENT FIGURES;TABLES

Vertical Vent Termination Clearances

VERTICAL (OFFSET) INSTALLATION

Frame Ceiling Opening

Install Firestop;Spacer and Support

Instructions for installing firestop/spacers and supporting vertical vent sections.

HORIZONTAL;INCLINED VENT INSTALLATION

Change Vent Direction

Install Flashing, Storm Collar, and Termination

Final steps for installing roof flashing, storm collar, and vertical termination.

HORIZONTAL VENT INSTALLATION

Frame Openings

Attach Vent Components

Attaching vent sections to the appliance and to each other.

Support Vent Sections

ASSEMBLE VENT RUN TO EXTERIOR WALL

Attach Termination Adapter

Attaching the adapter to the vent section or appliance collar.

Install Firestop;Spacer

Installing the firestop/spacer at the exterior wall opening.

Install Square Termination

Final steps for installing the square horizontal termination.

USING SECURE FLEX KITS

Install Inner Flex Pipe

Details the installation of the inner flexible vent pipe and adapter.

Install Outer Flex Pipe

Details the installation of the outer flexible vent pipe and adapter.

Route and Support Flex Vent

Install Firestop;Spacers

Instructions for installing firestop/spacers for flexible vent penetrations.

Attach Flex Vent to Termination

Describes attaching flexible vent to termination components.

FIELD WIRING

Millivolt Wiring

Wiring instructions for millivolt appliances with optional controls.

Electronic Wiring

Wiring instructions for electronic appliances, including main power connection.

Optional Blower Kit Wiring

CONNECTING GAS LINE

Gas Connection Diagram

Illustrates methods for connecting the gas supply line to the appliance.

TESTING GAS CONNECTIONS

Leak Testing Procedure

Appliance Operation Checkout

Procedure for checking the operation of millivolt appliances.

INSTALLING LOGS AND EMBERS

Place Logs

INSTALLING THE GLASS DOOR

Glass Door Installation Steps

BURNER ADJUSTMENTS

Flame Appearance and Sooting

Information on achieving proper flame appearance and avoiding sooting.

Air Shutter Adjustment Guidelines

Provides guidelines for adjusting the air shutter to optimize flame appearance.

BURNER AIR SHUTTER ADJUSTMENT

Air Shutter Adjustment Procedure

HOOD INSTALLATION

GAS CONVERSION KITS

Millivolt Conversion Kits

Electronic Conversion Kits

GAS CONVERSION KITS

Millivolt SIT Systems Conversion

Details conversion steps for SIT millivolt systems, including orifice replacement.

Millivolt Honeywell Systems Conversion

Details conversion steps for Honeywell millivolt systems, including gas type setting screw.

ELECTRONIC SYSTEMS CONVERSION

Honeywell Systems Conversion Steps

Details conversion steps for Honeywell electronic systems, including orifice replacement.

Reassembly and Labeling

Final Gas Connection Test

Superior SSDVT-4035CNM Specifications

General

Brand	Superior
Model	SSDVT-4035CNM
Category	Indoor Fireplace
Language	English