Supermicro AOC-MTG-i4SM - Installing Drivers on Freebsd

3-6
Super AOC-MTG-i4S Add-on Card User's Guide
The install locations listed above are the default locations. They may not be
correct for certain Linux distributions. For more information, see the ldistrib.txt
le included in the driver tar.
Note: IXGBE_NO_LRO is a compile time ag. The user can enable it at
compile time to remove support for LRO from the driver. The ag is used
by adding CFLAGS_EXTRA=-”DIXGBE_NO_LRO” to the make le when
it’s being compiled.
make CFLAGS_EXTRA=”-DIXGBE_NO_LRO” install
5. Load the module:
For kernel 2.6.x, use the modprobe command:
modprobe ixgbe <parameter>=<value>
For 2.6 kernels, the insmod command can be used if the full path to the driver
module is specied. For example:
insmod /lib/modules/<KERNEL VERSION>/kernel/drivers/net/
ixgbe/ixgbe.ko
In addition, when using 2.6-based kernels, make sure that older ixgbe drivers
are removed from the kernel before loading the new module. To do this, use:
rmmod ixgbe; modprobe ixgbe
6. Assign an IP address to the interface by entering the following, where x is the
interface number:
ifcong ethx <IP_address> netmask <netmask>
7. Verify that the interface works. Enter the following, where <IP_address> is the
IP address for another machine on the same subnet as the interface that is
being tested:
ping <IP_address>
3-6 Installing Drivers on FreeBSD
Follow the instructions below to install the drivers in FreeBSD kernel 4.8 or later.
In the instructions below, x.x.x is the driver version as indicated in the name of the
drive tar le.
Note: You must have kernel sources installed in order to compile the
driver module.