47
Chapter 2: Installation
CMOS Clear
JBT1 is used to clear the CMOS. Instead of pins, this jumper consists of contact pads to
prevent accidental clearing of the CMOS. To clear the CMOS, use a metal object such as a
small screwdriver to touch both pads at the same time to short the connection.
To Clear CMOS:
1. First power down the system and unplug the power cord(s).
2. Remove the cover of the chassis to access the motherboard.
3. Remove the onboard battery and the external CMOS battery installed on J18.
4. Short the CMOS pads with a metal object such as a small screwdriver for at least four
seconds.
5. Remove the screwdriver (or shorting device).
6. Install the batteries, the cover, reconnect the power cord(s), and power on the system.
Note: Clearing CMOS will also clear all passwords.
1. CMOS Clear
BAR CODE
BMC
AST2500
J1
SGPIO1
JBM1
JBM2
JD1
JPV1
J6
PJ1
JF1
LED3
FAN2
FAN1
FANA
M2_SRW1
JBT1
JWD1
JPG1
JVR1
JVRM1
JVRM2
JI2C1
JI2C2
JHDT1
JTPM1
JSTBY1
JSMB
SATA 2
SATA 1
SATA 0
BT1
JPI2C1
DIMMB2
DIMMA2
DIMMB1
DIMMA1
LED2
LEDM1
LED1
COM1
JMD2
JPCIE1
SATA 3
JGP1
M11SDV-4CT-LN4F
REV:1.02
DESIGNED IN USA
i350
1
CPU SLOT7 PCI-E 3.0 X16
SATA POWER
VGA
PCI-E 3.0 X4 M.2-HC
USB 6/7(3.0)
USB 4/5
USB 2/3
USB 0/1
CPU
IPMI_LAN
LAN 1/2
LAN 3/4
VGA
ON
PWR
JF1
RST
UID
X
OH/FF
2
NIC
1
LED
NIC HDD
LED
X
PWR
NMI
1-2:ENABLE
2-3:DISABLE
JPG1:
2-3:NMI
1-2:RST
JWD1:WATCH DOG
4-7:SPEAKER
1-3:PWR LEDJD1:
1-2:ENABLE
2-3:DISABLE
JI2C1/JI2C2:
UID
SUPER DOM
1
JBT1 contact pads
To Next Page
Loading...
