2-5
Super TPM User's Manual Chapter 2: Deploying and Using the TPM
3. In the command line at the bottom of the screen, follow these steps below
after typing “FS0:” 1. Go to directory “TPM2ProvTool” 2. Type the command
“TPM2TxtProv.nsh sha 256 default”. The Provisioning process is now
completed.
4. After the provisioning process has completed, you will need to go back into
the BIOS and enable TXT Support. To do this, type "exit" in the command
line at the bottom of the screen and press the <Enter> key.
To Next Page
Loading...
