Super X11DDW-L/N(T) User's Manual
208
Get target info via DHCP (available when Enable DHCP is set to Enabled)
Use this feature to disable/enable dynamic host conguration protocol (DHCP) server service
for the iSCSI target. The options are Disabled and Enabled.
Note 1: Set the feature, Get target info via DHCP, to Disabled if you would like to
specify the iSCSI target name/IP address/boot LUN.
Note 2: LUN stands for logical unit number, which is used to identify a logical/physical
disk.
Target Name
Use this feature to enter the desired iSCSI target name in IQN format.
To Next Page
Loading...
