Appendix G: Confi guring iSCSI Settings
201
iSCSI Mode
Use this feature to set the iSCSI mode. The options are Disabled, Enabled, and Enabled
for MPIO. Multipath I/O (MPIO) is a feature that allows the system to route I/O through the
available paths if the active path fails (be sure to have more than one physical path connected
to the system).
Internet Protocol
Use this feature to set the Internet protocol. The options are IPv4, IPv6, and Autoconfi gure.
Note: Enabling the feature, iSCSI Mode, is required for iSCSI confi guration.
To Next Page
Loading...
