Supermicro X11DPH-i - Page 96

Super X11DPH-i/X11DPH-T/X11DPH-Tq User's Manual
96
SATA HDD Unlock (Available when sSATA Controller is set to Enable)
Select Enable to unlock sSATA HDD password in the OS. The options are Enable and Disable.
SATA RSTe Boot Select (Available when Confi gure SATA as is set to RAID)
Select Enable for full int13h support which will allow the system to boot using a device attached
to the SATA controller. The options are Disable and Enable.
Aggressive Link Power Management
When this feature is set to Enable, the sSATA AHCI controller manages the power use of the
sSATA link. The controller will put the link in a low power mode during an extended period of
I/O inactivity, and will return the link to an active state when I/O activity resumes. The options
are Disable and Enable.
sSATA RAID Option ROM/UEFI Driver (Available when Confi gure sSATA as is set to
RAID)
Select EFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for
system boot. The options are Disable, EFI, and Legacy.
sSATA Port 4 - sSATA Port 5
Hot Plug
Select Enable to support Hot-plugging for the device installed on an sSATA port specifi ed by
the user which will allow the user to replace the device installed in the slot without shutting
down the system. The options are Enable and Disabled.
Spin Up Device
This setting allows the SATA device installed on the SATA port specifi ed by the user to
start a COMRESET initialization when an edge is detected from 0 to 1. The options are
Enable and Disable.
sSATA Device Type
Use this feature to specify if the device installed on the sSATA port specifi ed by the user
should be connected to a Solid State drive or a Hard Disk Drive. The options are Hard
Disk Drive and Solid State Drive.

PCIe/PCI/PnP Confi guration
The following PCI information will be displayed:
• PCI Bus Driver Version
• PCI Devices Common Settings
Above 4G Decoding (Available if the system supports 64-bit PCI decoding)
Select Enabled to decode a PCI device that supports 64-bit in the space above 4G Address.
The options are Enabled and Disabled.