Supermicro X11SSQ-L - Page 127

Chapter 5: BIOS
127
Serial Port 2
This submenu allows the user the congure settings of Serial Port 2.
Serial Port 2
Select Enabled to enable the selected onboard serial port. The options are Enabled and
Disabled.
Logical Device Settings
This item displays the status of a serial part specied by the user.
Serial Port 2 Change Settings
This feature species the base I/O port address and the Interrupt Request address of a
serial port specied by the user. Select Auto to allow the BIOS to automatically assign the
base I/O and IRQ address.
The options for Serial Port 2 are Auto, (IO=2F8h; IRQ=3;), (IO=3F8h; IRQ=3, 4, 5, 6, 7, 9,
10, 11, 12;), (IO=2F8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12;), (IO=3E8h; IRQ=3, 4, 5, 6, 7, 9, 10,
11, 12;), and (IO=2E8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12;).
PCH-FW Conguration
The following rmware information will display:
• ME FW Version
• ME Firmware Mode
• ME Firmware Type
• ME Firmware SKU
ME FW Image Re-Flash
Use this feature to update the Management Engine rmware. The options are Enabled and
Disabled.
Serial Port Console Redirection
COM1 Console Redirection
Select Enabled to enable console redirection support for a serial port specied by the user.
The options are Enabled and Disabled.
*If the item above is set to Enabled, the following items will become available for user's
conguration: