Supermicro X11SSQ-V - Page 85

Chapter 4: BIOS
85
SLOT5 PCIe Speed
Use this feature to select the PCI Express port speed. The options are Auto, Gen1, Gen2,
and Gen3.
SLOT5 Detect Non-Compliance
Select Enabled for the AMI BIOS to automatically detect a PCI-E device that is not compliant
with the PCI-E standards. The options are Disabled and Enabled.
PCH SLOT6 PCI-E 3.0 X1
SLOT6 ASPM
Use this item to set the Active State Power Management (ASPM) level for a PCI-E device.
Select Auto for the system BIOS to automatically set the ASPM level based on the system
conguration. Select Disabled to disable ASPM support. The options are Disabled, L0s,
L1, L0s & L1, and Auto.
SLOT6 L1 Substates
Use this feature to set the PCI Express L1 Substates. The options are Disabled, L1.1,
L1.2, and L1.1 & L1.2.
SLOT6 PCIe Speed
Use this feature to select the PCI Express port speed. The options are Auto, Gen1, Gen2,
and Gen3.
SLOT6 Detect Non-Compliance
Select Enabled for the AMI BIOS to automatically detect a PCI-E device that is not compliant
with the PCI-E standards. The options are Disabled and Enabled.
Port 61h bit-4 Emulation
Select Enabled to enable the emulation of Port 61h bit-4 toggling in SMM (System Management
Mode). The options are Disabled and Enabled.
PCIe PLL SSC
Enable this feature to reduce EMI interference by down spreading the clock 0.5%. Disable
this feature to centralize the clock without spreading. The options are Disabled and Enabled.
SATA Conguration
When this submenu is selected, the AMI BIOS automatically detects the presence of the SATA
devices that are supported by the Intel PCH chip and displays the following items: