Supermicro X11SSQ - Quick Reference Table

13
Chapter 1: Introduction
Note: Table is continued on the next page.
Quick Reference Table
Jumper Description Default Setting
JAT1 ATX/AT mode Pins 1-2 (ATX mode)
JBT1 CMOS Clear Open (Normal)
JI
2
C1/JI
2
C2 SMB to PCI-E Slots Enable/Disable Pins 2-3 (Disabled)
JPAC1 Audio Enable Pins 1-2 (Enabled)
JPL1/JPL2 LAN1/2 Enable/Disable (JPL2 on X11SSQ/-V only) Pins 1-2 (Enabled)
JPME2 Manufacturing Mode Pins 1-2 (Normal)
JWD1 Watch Dog Pins 1-2 (Reset)
LED Description Status
CATERR_LED Catastrophic Error LED Orange: CAT Error
LED1 Power LED Green: Power On
LED3 Standby Power LED Green: Power On
Connector Description
AUDIO FP Audio Front Panel Header
B3 Onboard Battery
COM1 ~ COM4 COM Headers (COM3/COM4 on X11SSQ/-V only)
DVI-D Digital Video Interface Port (Back Panel)
FAN1 ~ FAN4 System/CPU Fan Headers (FAN1: CPU Fan)
HD Audio High Denition Audio Connector (Back Panel)
HDMI/DP High Denition Multimedia Interface/DisplayPort Connector (Back Panel)
I-SATA0 ~ I-SATA5 Intel® SATA 3.0 Ports (I-SATA0 supports SuperDOM) (I-SATA4/5 on X11SSQ/-V only)
I-SGPIO1/I-SGPIO2 Serial General Purpose I/O Headers for SATA (X11SSQ/-V only)
J18 Embedded DisplayPort (eDP) (X11SSQ only)
J23 M.2 Connector (X11SSQ/-V only)
JD1 Speaker/Buzzer Header (Pins 1-4: Speaker, Pins 3-4: Buzzer)
JF1 Front Control Panel Header
JL1 Chassis Intrusion Header
JLED1 3-Pin Power LED
JP7 General Purpose I/O Header (X11SSQ/-V only)
JPW1 24-pin ATX Main Power Connector (Required)
JPW2 +12V 4-pin CPU Power Connector (Required)
JSD1 SATA DOM Power Connector
JSMB1 SMBus Header
JSTBY1 Standby Power Header
JTPM1 Trusted Platform Module/Port 80 Connector
KB/Mouse Keyboard/Mouse Connector (Back Panel)
LAN1/LAN2 LAN (RJ45) Ports (LAN2 on X11SSQ/-V only)