Supermicro X11SSQ - Page 90

Super X11SSQ/-L/-V User's Manual
90
Serial Port 3 Change Settings
This feature species the base I/O port address and the Interrupt Request address of a
serial port specied by the user. Select Auto to allow the BIOS to automatically assign the
base I/O and IRQ address.
The options for Serial Port 3 are Auto, (IO=240h; IRQ=7;), (IO=240h; IRQ=3, 4, 5, 6, 7, 10,
11, 12;), (IO=248h; IRQ=3, 4, 5, 6, 7, 10, 11, 12;), (IO=250h; IRQ=3, 4, 5, 6, 7, 10, 11, 12;),
and (IO=258h; IRQ=3, 4, 5, 6, 7, 10, 11, 12;).
Serial Port 4
This submenu allows the user the congure settings of Serial Port 4.
Serial Port 4
Select Enabled to enable the selected onboard serial port. The options are Enabled and
Disabled.
Logical Device Settings
This item displays the status of a serial part specied by the user.
Serial Port 4 Change Settings
This feature species the base I/O port address and the Interrupt Request address of a
serial port specied by the user. Select Auto to allow the BIOS to automatically assign the
base I/O and IRQ address.
The options for Serial Port 4 are Auto, (IO=248h; IRQ=7;), (IO=240h; IRQ=3, 4, 5, 6, 7, 10,
11, 12;), (IO=248h; IRQ=3, 4, 5, 6, 7, 10, 11, 12;), (IO=250h; IRQ=3, 4, 5, 6, 7, 10, 11, 12;),
and (IO=258h; IRQ=3, 4, 5, 6, 7, 10, 11, 12;).
PCH-FW Conguration
The following rmware information will display:
• ME FW Version
• ME Firmware Mode
• ME Firmware Type
• ME Firmware SKU
ME FW Image Re-Flash
Use this feature to update the Management Engine rmware. The options are Enabled and
Disabled.