Press ON/TEST immediately. A series of asterisks will appear across the screen, followed by the moisture
reading.
The analyser will take ~10sec to measure the moisture content and calculate the temperature
compensation and hereafter display the result.
A new reading can be made by emptying and cleaning the test cell and filling it with a new sample. Do not
re-test the sample without first emptying and refilling.
Note: In order to ensure correct measurements, clean both grinder discs thoroughly with the
enclosed cleaning brush after each measurement. Remnants of sticky or moist material can
be removed by grinding a dry grain sample.
Note: When grinding crops with high water content there may be a risk of the two grinder discs
touching one another so that the display reads Hi. If this happens, carry out a new
measurement with an increased sample size. Try with approx. 2-3 ml more than the quantity
specified in the display. In particular, when measuring maize with more than 20 % moisture
(and some grass types), 18ml (2x9 ml) must be measured out for grinding, as stated in the
display.
Note: If the temperature of the grain sample differs a great deal from that of the result in the
unit, e.g. measurements taken directly from the dryer, it is recommended to preheat the tester
as follows:
To Next Page
Loading...
Need help?
General