Answer a Call:
During the ring tone, press Accept Button for 1 second to answer the call.
End a Call:
When conversation is over, press End/Reject Button for 1 second to end the
call.
Reject a Call (For Handsfree Profile Phones only) :
During the ring tone, press End/Reject Button. The incoming call will be
rejected.
Volume Setting:
Increase or decrease the volume by pressing the volume up or volume down
button. Press repeatedly until desired level is reached.
Audio Transfer (For Handsfree Profile Phones only) : During an ongoing call,
you can transfer the audio.
Kit to Phone: Push in the microphone shaft (or turn off the kit). The audio
will be transferred to the phone.
Phone to Kit: Press-and-release the microphone shaft (or turn on the kit).
Some phones do not connect automatically to the kit after turning on. With
these phones, you need to press Accept Button for 1 second. Then the
audio will be transferred to the kit.
Advanced Functions
Multi-Pairing / Switching Connections Between Phones
The ST LIGHT can be paired to 5 Bluetooth phones. An additional pairing will
automatically delete the phone that has not been used for the longest time.
Thus, maintaining 5 phones in its memory.
You can easily switch to any of the paired phones by:
1. Disconnecting the currently used phone using the “Active devices” in the
Bluetooth menu of that phone and then;
2. Connect to the wanted phone by using the “Paired devices” in the
Bluetooth menu of that wanted phone.
Note: Reconnection to a paired phone can also be done by pressing the Accept
Button. But when you press the Accept Button, the ST LIGHT will attempt to
connect to the last used phone only. It is recommended to connect to the ST
LIGHT using your phone.
To Next Page
Loading...