29© 2002 Skier’s Choice, Inc.
The navigation light switch supplies power to the Bow Light,
the Stern Light and the Pole Light.
Operation
When underway during night time operation, set the switch in
the NAV position to activate all of the running lights.
When docked or at anchor, set the switch i the ANC position
to activate only the pole light.
NOTICE: If lights fail to operate, press the circuit breaker
under the dash.
Navigation Lights Switch Accessory Switch
The accessory switch supplies power to an extra circuit for
accessories that may be added (such as heaters, hot water
showers, etc.).
NOTICE: If accessories fail to operate, press the circuit
breaker.
The blower switch activates the blower motor. The primary
function of the blower fan is to remove any fumes from the
bilge area. The blower also draws fresh air into the engine
compartment.
Never depend solely on the blower to eliminate dangerous
fumes. Before starting the engine, always open the motor
box to check if fumes are present. Switch on the blower fan a
minimum of four minutes before starting the engine.
NOTICE: If the blower fails to operate, reset the circuit
breaker. If the blower still does not operate, notify your
Supra dealer.
Failure to operate the blower in accordance with the Coast
Guard Recommendation could result in an explosion.
Blower Switch
To Next Page
Loading...
